Recommendations for storage battery
You are always running battery power, just before the perfect picture with your digital camera? Here are some
Tips to preserve the batteries, if you click on. "
1) Turn off the digital camera when not in use. If you are in a situation where you have to take pictures quickly, this can not
They are considered as digital cameras and off a few seconds, and can cause a missed recording opportunities.
However, if you have a pleasant stroll and can afford it, a few seconds before the snap or the object of all
Means to conserve energy on a digital camera!
2) Many digital cameras have a regular viewfinder and an LCD viewfinder. While the digital LCD viewfinder has its benefits
May drain the battery. Turn it off, if necessary, and use the viewfinder to adjust the recording.
3) Do not stop after taking all the photos and watch the image in a digital camera to playback mode. Of course, sometimes
Need to look at photos immediately after shooting, to ensure that the request is correct, the lighting is in order,
etc., but to use the digital camera battery.
4) If you MicroDrive media, be forewarned that these miniature hard drives may take up much more power than the
Compact Flash card.
It 'a new battery
Normally, a new battery is available in a very low charge and needs to use fully charged. Refer to the user
Manual portable electronic device for charging instructions. A new battery must be fully charged and
fully discharged or "bicycle" as up to five times the condition for the implementation at full capacity. Their equipment
on condition that you fully charge the shorter 10 to 15 minutes, when the new battery will be the first
Time. This is a normal phenomenon, especially for nickel-cadmium (Ni-Cd) and nickel-metal hydride (Ni-MH) chemistry. When
this is the case, remove the battery and let it cool
for about fifteen minutes, then repeat the charging procedure. "Conditioning" (fully discharge and then fully charged)
is necessary to ensure optimal performance of the battery, and is recommended at least once a month
Particularly for Ni-Cd and Ni-MH batteries. Not to do so could lead to reduced costs and can significantly
Shorten the useful life of batteries. Lithium-ion batteries, no air conditioning. And 'normal for a battery
Warm during charging and during use. However, when the battery is too hot, this can be a problem with the
portable electronic devices charging circuit and should therefore be conducted by a qualified technician. Rechargeable
Batteries are discharged even if for a long period of time. This is normal, especially in the case of Ni —
MH and Li-Ion Chemie. For best results, always save the battery is fully charged. It should be excluded from
Equipment and in a cool, dry and clean place. The amount of software to produce a battery depends on the power
Requirements of the components in your electronic equipment.
Do not be under-batteries do you think of the big picture.
If rarely with the digital camera, you might think that after the digital camera, upload your NiMH
Batteries, wait a few weeks or months, then with your digital camera batteries that are and will
Ready to take pictures, right?
Oops … Doing, and was blocked with a non-functioning or a digital camera that flashes a picture of a dead
Battery.
Rechargeable batteries are not charged to stay forever. They tend to lose some 'of their power every day. If you free
Batteries, and, often, digital camera, you will probably never notice the loss of power. But after a
few weeks, the loss of power can do, and after a few months or more is not being used, once the "ready-to-go
The batteries may have lost enough power to make them unusable.
Do not get caught in this trap. Also the batteries before every trip, and make sure that the charger with a sensor that prevents over-charging.
More information: http://www.camera-battery.org